Here are a few quick guides for setting up certain devices and networks.
Note: Before deploying any wireless device please ensure you are familiar with your responsiblities under the "General User Radio Licence for Short Range Devices"
This Basic guide will explain the absolute basics of IP Addressing. This is an essential read for anyone attempting to follow these guides below as they assume you have basic TCP/IP knowledge.
Configuring a basic EnGenius WDS Network (ECB Series)
This guide shows you how to setup two EnGenius ECB-1221R Routers in WDS mode. This is perfect for extending the range of your wireless network out to the sleepout or garage or to provide better coverage through the house.
Configuring a basic EnGenius WDS Network (EOC Series)
This guide shows you how to setup two EnGenius EOC Series Access Points in WDS mode. This is perfect for extending the range of your wireless network out to the shed or office with wireless coverage between the two sites.
Configuring a basic EnGenius Mesh Network
This guide is shows you how to setup a Mesh network using any of EnGenius' Mesh devices ready to monitor and maintain through EnGenius' Network Management Software. This is ideal for Motels or small Schools with limited Ethernet cabling and only one point of contact to the local network.
Configuring an EnGenius router as a Repater
This guide explains how to setup an EnGenius ECB1221R / ESR1221EXT Router as a repeater. This is ideal for extending the range of your current wireless network if you have poor coverage around the house.
Basic 3G carrier settings for EnGenius 3G Routers
This guide consists of the settings to configure your Vodafone or Telecom 3G USB dongle with any of our EnGenius 3G Routers.
Ubiquiti Access Point Quick Setup Guide:
This quick guide will show you how to setup a Ubiquiti Device as a High Powered Access Point for your network in a few simple steps.
Configuring a Ubiquiti Point to Point WDS Bridge
This guide explains how to setup a Ubiquiti Point to Point WDS Bridge using either the Standard or AirMax Access Points. This is ideal for creating a bridge across the farm or between two sites.
Ubiquiti Wireless Distrution System Network:
In this setup guide you will see how to configure a Wireless Distribution System using Ubiquiti Access Points. This allows users to seamlessly roam through a site wouthout losing connectivity to the network using multiple Access Points.
This quick guide is a beginners guide on how to setup a Ubiquiti Nanostation as a client/receiver to connect to an Access Point or Hotspot.
Configure Telecom XT MF626 USB Adaptor for MikroTik
This guide explains how to setup the Telecom XT MF626 USB dongle on a Mikrotik Router.
MikroTik RouterBoard - Performing a Netinstall
This quick guide will show you how to perform a netinstall on all RouterBoard products (with and without serial interface).
